STRANDS SIBERIA CABLE KIT PROFESSIONAL 3X DT
A professional cable set with 3x DT connector. Adapted for all our
additional lights with a maximum consumption of 3x156W or a maximum of 480W if
the DT connector is cut. Works great for connecting three extra lights/LED
ramps. A fast, simple and professional installation. The Nordic climate creates
both opportunities and dangers for the vehicle out on the roads. On the Siberia
cable set pro 3x DT, a protective tube surrounds the cables and the DT
connector to provide extra protection. Both a mechanical protection against
impact and wear and against dirt and water. The signal cable (brown 86) is used
to connect the relay with our Canbus Interface. If the car is not affected by
Canbus, the signal is picked up directly from the car’s headlights with this
cable. Siberia cable set professional 1x DT has more possibilities of use.
Namely, Output 2 (blue 87A) is added, which is used to control another signal
such as the position light on Siberia and the Dark Knight series. Output 2 is
used when using XBB. From the cable kit comes a 2 pin DT connector and as both
the Siberia and Dark Knight series use 4 pin DT connectors due to dual position
lights it ships with an adapter cable to convert from 4 pin to 2 pin DT
connector. On the adapter cable there are also two loose cables that are used
to power the position light. The DT connector is only adapted for a consumption
of 156W and if you are to connect more that consume more than 156W, this cable
set can handle a total of up to a maximum of 480W if the DT connector is cut
off. Can, for example, be used for 42″ and 52″ Siberia DR LEDBAR. Siberia cable
set professional 3x DT makes it easy to carry out a professional installation.
If you need to cut the cable for various reasons, you can easily do so. Because
there are two watertight, shrinkable joint sleeves that make it possible to
make a safe and tight closure afterwards and a hose clamp to reconnect the
protective hose. But it is important that you cut at least 50 cm from the relay
to ensure that the cable does not come into contact with any moisture. – For
connecting lighting with both two-pole DT connector and four-pole DT connector.
– Protective hose that protects against impact and wear as well as moisture and
dirt. – Possibility to adjust the length of the cable, for a simpler and more
attractive assembly. – An extra cable (blue 87A) for connection of, for
example, XXB. To connect, for example, position lights.
Leave a Review
Your email address will not be published. Required fields are marked *